121
EN
Press the right button
The third push-pull calibration screen is shown:
Follow the instructions shown
CAUTION! Risk of injury from rotating cogs and drive parts. Keep hands away
from rotating cogs and the wire drive.
Press the right button
The fourth push-pull calibration screen is shown:
Follow the instructions shown
CAUTION! Risk of injury from welding wire emerging at speed and from rotating
cogs and drive parts. Hold the welding torch so that it points away from your face
and body. Keep hands away from rotating cogs and the wire drive.
Press the right button
A confirmation appears once the push-pull unit has been calibrated:
Press the right button
The cold wire setup welding parameters are shown:
5
6
7
8
9
10
To Next Page
Loading...
