135
EN
Break-voltage
Welding voltage limitation
Unit -
Setting range OFF or 5 - 90 V
Factory setting OFF
The arc length depends on the welding voltage. To end the welding process, it is usually
necessary to significantly lift the rod electrode away from the workpiece. With the “Uco”
parameter, the welding voltage can be limited to a value that makes it possible to end the
welding operation simply by slightly lifting the rod electrode.
NOTE! If the welding process is stopped unintentionally during the welding, in-
crease the value for the Uco parameter.
L/R alignment
L (inductivity) - welding circuit inductivity (in microhenry)
R (resistance) - welding circuit resistance (in mOhm)
See the "L/R alignment" section for further details.
To Next Page
Loading...
