Fronius TransTig 800 Job - Terms and Abbreviations Used; General; Terms and Abbreviations a - C; Terms and Abbreviations D - E

142
Terms and abbreviations used
General The terms and abbreviations listed here are used in connection with functions that are ei-
ther included in the standard scope of supply or that are available as optional extras.
Terms and abbre-
viations A - C
Terms and abbre-
viations D - E
ACF
AC frequency
ACS
Automatic current switch
Switchover to main current
Arc
Arc
Arc break watchdog
ASt
Anti-stick
For reducing the effect of a “sticking” rod electrode (MMA welding)
bAL
Balance
When "bAL" is selected for the external parameter "E-P", the balance on the JobMaster
TIG welding torch can be adjusted.
C-C
Cooling unit control
COr
Correction
Gas correction; modification of the digital gas control to different protective gas shields
(digital gas control option)
C-t
Cooling time
Time from when the flow watchdog is triggered until the "no | H2O" service code is output.
dcY
duty cycle
Ratio of pulse duration to base current duration (in TIG AC welding)
dt1
delay-time 1
Wirefeed start delay time (only where an optional cold wire-feed unit is connected)
dt2
delay-time 2
Wirefeed end delay time (only where an optional cold wire-feed unit is connected)
dYn
dynamic
Arc force dynamic correction for standard arcs, pulse correction for pulsed arcs or correc-
tion of various welding parameters in CMT (job correction or arc force dynamic and pulse
correction settings in the set-up menu for the Standard control panel)