Fronius TransTig 800 Job - Spot Welding

61
EN
Spot welding If a value has been set for the SPt set-up parameter, 2-step mode will have the spot weld-
ing mode function. The special spot welding indicator on the control panel will light up.
- Welding: briefly pull back the torch trigger
The welding time corresponds to the value set for the SPt set-up parameter.
- to end the welding process prematurely: pull the torch trigger back again
When using a pedal remote control, the spot welding time starts when the pedal remote
control is operated. The power cannot be controlled using the pedal remote control.
Spot welding
I
t
I
1
GPr t
up
t
down
SPt
G-L
G-H
I
S
t
E
I
E
t
S