Fronius TransTig 800 Job - Rod Electrode Setup Menu: Level 2; Opening the Rod Electrode Set-Up Menu Level 2; Changing Welding Parameters; Exiting the Rod Electrode Set-Up Menu - Level 2

115
EN
Rod electrode setup menu: level 2
Opening the rod
electrode set-up
menu level 2
Changing weld-
ing parameters
Exiting the rod
electrode set-up
menu - level 2
Welding parame-
ters in the rod
electrode setup
menu - level 2
Open the rod electrode set-up menu
Select "2nd" welding parameter
Press and hold the Store button
Press the Mode button
The power source is now in the rod electrode set-up menu - level 2. The
last welding parameter selected is displayed.
1
2
3
4
Use the left or right parameter selection button to select the welding pa-
rameter that you want to change
Use the adjusting dial to change the welding parameter value
1
2
Press the Store button
The power source is now in the rod electrode set-up menu
To exit from the rod electrode set-up menu, press the Store button again
1
2
r
r (resistance) - welding circuit resistance (in mOhm)
see "Measuring the welding circuit resistance r"
L
L (inductivity) - Welding circuit inductivity (in microhenry)
see "Displaying welding circuit inductivity L"
ASt
Anti-stick
Unit -
Setting range ON / OFF
Factory setting ON
As the arc becomes shorter, the welding voltage may drop so far that the rod electrode
will tend to stick. This may also cause the rod electrode to burn out.
Electrode burn-out is prevented by activating the anti-stick function. If the rod electrode
begins to stick, the power source immediately switches the welding current off. After the
rod electrode has been detached from the workpiece, the welding process can be contin-
ued without any problems.