Fronius TransTig 800 Job - Terms and Abbreviations F; Terms and Abbreviations G - H

143
EN
Terms and abbre-
viations F
Terms and abbre-
viations G - H
Eld
Electrode diameter
When "Eld" is selected for the external parameter "E-P", the electrode diameter on the
JobMaster TIG welding torch can be adjusted.
ELn
Electrode line
Characteristic selection (MMA welding)
E-P
External parameter
Freely selectable welding parameter for the JobMaster TIG welding torch
FAC
Factory
Reset welding machine
FCO
Feeder control
Wire-feed unit cut-out (wire end sensor option)
Fd.1
Feeder1
Wire feed speed 1 (only where an optional cold wire-feed unit is connected)
Fd.2
Feeder2
Wire feed speed 2 (only where an optional cold wire-feed unit is connected)
Fdb
Feeder backward
Withdraws wire to prevent it from being burned at the welding end (cold wire-feed unit op-
tion).
Fdi
Feeder inching
Feeder inching speed
F-P
Frequency-Pulse
Pulse frequency
GAS
Gasflow
Set value for protective gas shield flow
G-H
Gas post-flow time high
Gas post-flow time at maximum welding current
G-L
Gas post-flow time low
Gas post-flow time at minimum welding current
GPR
Gas pre-flow time
GPU
Gas purger