85
EN
Press and hold the Store button
NOTE!
If the selected program location already has a job stored in it, the existing job will be
overwritten by the new one.
This action cannot be undone.
The left-hand digital display reads "Pro" - the job is copied to the program location you
have just selected.
"PrG" appears on the left-hand digital display to indicate that the job has been copied.
Release the Store button
Briefly press the Store button to exit from the Job menu
The power source switches to the setting selected before the job was copied.
Deleting a job Stored jobs can also be deleted again. To delete a job, proceed as follows:
Briefly press the Store button to switch to the Job menu.
The first vacant program location is shown.
Using the adjusting dial, select the job to be deleted (the "DEL" symbol lights up
on the Gas test button).
Press and hold the Gas test "DEL" button.
The left-hand digital display reads "dEL" - the job is deleted.
"nPG" appears on the left-hand digital display to indicate that the job has been deleted.
Release the Gas test button
Briefly press the Store button to exit from the job menu.
The power source switches to the setting selected before the job was deleted
5
7
1
2
3
4