Fujitsu Airstage J-II Series User Manual


INDOOR UNIT SETTING
Refer to the correct SW position for 2. Function Setting.
Refrigerant circuit address setting
Indoor unit address setting
Remote controller address setting
Function setting
Set the Rotary SW REF AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW IU AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW RC AD.
For details, refer to "1-2. Address setting".
<Step 1>
<Step 2>
<Step 3>
<Step 4>

RB UNIT SETTING
Refer to the correct SW position for 2. Function Setting.
(This function is available VR-II series.)
Refrigerant circuit address setting
RB unit address setting
Set the Rotary SW REF AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW RB AD x10 & x1.
For details, refer to "1-2. Address setting".
<Step 1>
<Step 2>

REMOTE CONTROLLER SETTING
(Only for Wired remote controller and Simple remote controller)
Dual remote control setting
Set the SW 2 of DIP Switch 1.
For details, refer to "2. Function setting".
¾
Other than the unit above, refer to "2. Function setting" and the installation manual.
- (07 - 02) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English