Fujitsu Airstage J-II Series User Manual

1-5. AUTOMATIC ADDRESS SETTING
The addresses of signal ampliers, indoor units and RB units can be set automatically.
Caution
Following are cautions when performing AUTOMATIC ADDRESS SETTING.
1. The Controller cannot be used.
2. AUTOMATIC ADDRESS SETTING may take about 30 minutes.
3. Emergency stop signal is not accepted.
Refer to Chapter 8. EXTERNAL INPUT & OUTPUT for design related to emergency stop.
When setting addresses of signal ampliers, indoor units and RB units automatically, be
sure to always set the addresses of signal ampliers rst, set the addresses of indoor units
second, set the addresses of RB units last.

AUTOMATIC ADDRESS SETTING METHOD
Manual setting of Outdoor unit
Set up 1-3 (Set A, Set B, Set C, Set L) and 1-8 (terminal resister setting).
This function is available VR-II series.
<Step 1>
Turn Power ON of all units
<Step 2>
Automatic address setting of Signal Amplifier (1-5-1)
<Step 3>
Automatic address setting of Indoor unit (1-5-2)
<Step 4>
Automatic address setting of RB unit (1-5-3)
<Step 5>
NOTE: Do not change an order of step 1 to step 5.
- (07 - 44) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English