2-3. INDOOR UNIT (setting by wireless remote controller)
●
This procedure changes to the function settings used to control the indoor unit according to
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
●
After the power is turned on, perform the “FUNCTION SETTING” according to the
installation conditions using the remote controller.
●
The settings may be selected from the following: Function Number or Setting Number.
●
Settings will not be changed if disable numbers or setting numbers are selected.
PREPARATION
(1) Turn on the power to the indoor unit.
¾
By turning on the power indoor units initializes EEV, so make sure the pressure testing and vacuum drying
have been conducted before turning on the power.
¾
Also check again to make sure no wiring mistakes were made before turning on the power.
Indoor
units
Breaker ON
Indoor
units
- (07 - 89) -
FUNCTION
SETTING
FUNCTION
SETTING
To Next Page
Loading...
Need help?
General
