Fujitsu Airstage J-II Series - Page 694

6) When automatic address setting is completed, the number of signal amplier is displayed on
the LED104. Verify that the count matches the number of signal ampliers being installed.
LED105 LED104
LED105 LED104
Ex.) When eight signal ampliers are being connected
7) To exit automatic address setting, press the ENTER button (SW109) in the setting completed
status shown in step 6) above.
LED105 LED104
LED105 LED104
Next, press the MODE/EXIT button (SW107) to exit the Function mode.
LED105 LED104
LED105 LED104
- (07 - 47) -
FUNCTION SETTING FUNCTION SETTING