Fujitsu Airstage J-II Series - Page 756


SWITCHING SELECTION OF FUNCTION SETTING MODE
3) To activate the function setting mode, hold down the three buttons of SET TEMP.
q
, SET
T E M P.
p
and FAN at the same time for 5 seconds or longer.
Function setting mode initial display

BUTTON NAME AND FUNCTION
● During function setting mode, indoor unit reject the any operation command from remote controller.
Function number
Refer to FUNCTION DETAILS
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Refer to FUNCTION DETAILS
START/STOP button
Transmits function setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers.
UTY-RSKU (With operation mode)
Function number
Refer to FUNCTION DETAILS
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Refer to FUNCTION DETAILS
START/STOP button
Transmits function setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers.
UTY-RHKU (Without operation mode)
- (07 - 109) -
FUNCTION SETTING FUNCTION SETTING