Fujitsu Airstage J-II Series - Page 853


EXTERNAL HEATER OUTPUT
(External output4)
Control
Primary
heater
Auxiliary
heater
Installation
congration
Function Setting
Recommended
connection
Indoor unit Wired R. C. Outdoor unit
Control
switching
external heaters
No.61
IU fan setting
for external
heater
DIP-SW2-3
Sensor
activation
(UTY-RNRU,
UTY-RNRUZ*,
UT Y- RSRY,
UTY-RHRY, or
UTY-RNKU)
Presence of
heater selection
control using
outdoor unit
sensor No.35
Auxiliary heater
control 1
VRF Heat
Pump
External
device
(Hot water
electrical
heater,
etc.)
In-line
61-00
ON (Enable) - -
●
Individual OFF - - -
Auxiliary heater
control 2
VRF Heat
Pump
External
device
(Hot water
electrical
heater,
etc.)
In-line
61-01
ON (Enable) - -
●
Individual OFF - - -
Heat pump
prohibition
control
External
device
(Hot water
electrical
heater,
etc.)
None
In-line
61-02
ON (Enable) - -
●
Individual OFF ON (Enable) *2 - -
Heater
selection
control by
outdoor
temperature 1
*1
VRF Heat
Pump
External
device
(Hot water
electrical
heater,
etc.)
In-line
61-03
ON (Enable) -
35-01 (Enable)
●
Individual OFF ON (Enable) *2 -
Heater
selection
control by
outdoor
temperature 2
*1
External
device
(Floor
heating
device,
etc.)
VRF Heat
Pump
In-line
61-04
ON (Enable) -
35-01 (Enable)
-
Individual OFF ON (Enable) *2
●
NOTES :
● Corresponding indoor units: Except wall mounted type.
● After turning off the heater, 3 minutes of standby time is required by next power-on of the heater.
● For items marked "-" in the table, any of validate or invalidate of the setting are acceptable.
● For shaded items in the table, setting change from the factory setting is required.
¾
1: Only available with VR-II or J-II
¾
2: Indoor unit fan setting will be ON for safety reason without sensor activation of Wired R.C.
- (08 - 33) -
EXTERNAL INPUT & OUTPUT EXTERNAL INPUT & OUTPUT