USING SETUP MODE
User's Manual 5-61
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<CNT-LD> Selection for the paper feeding of
continuous forms paper
PRCIS-1 Precision is the first priority.
PRCIS-2 Speed is the first priority.
Reduces the disturbance of line
break outstretching fold of the paper
by over feeding during the process of
paper feeding
SPEED Speed is the first priority.
<CSF-LD> Selection of the method of feeding
from the CSF
NORMAL Feeds paper directly from the CSF
hopper.
SWBACK Feeds paper from the CSF hopper to
either the paper table used with a
front CSF or the stacker used with a
rear CSF. Then, that paper is fed
again.
<CSFAPTC> Paper thickness detection with use of
a CSF
NORMAL Sheet of paper that is fed immediately
after the feed bin is switched
Detect the paper thickness at 1st page
when printing from Cut sheet feeder
continuously.
ALWAYS Detect the paper thickness of every
paper when printing from Cut sheet
feeder.
To Next Page
Loading...
