USING SETUP MODE
5-66 User's Manual
Procedure (for LCD type)
To exit setup mode and save or cancel your changes using SAVE/EXIT
function, proceed as follows:
1. Push SAVE/EXIT button.
Push SAVE/EXIT button, then “:SAVE :CANCEL” is
displayed on LCD PANEL
2. Push or button.
Push to save changing.
Push to cancel changing.
This section describes how to reset the printer’s power-on defaults, all of
the factory defaults, or the factory defaults only for MENU1 and
MENU2.
Resetting Power-On Defaults
Power-on defaults are the settings saved in the printer’s permanent
memory. The defaults are enabled whenever you turn the printer on.
The only (LED type) way to reset the power-on defaults is to turn the
printer off and then on again. This method is useful if you have made
changes in setup mode that you do not want to save. LCD type, save or
cancel options are available on exit menu.
Resetting Factory Defaults
Factory defaults are those settings preselected at the factory. For a list of
the printer’s factory defaults, see the section Printing a List of Selected
Options earlier in this chapter. To reset the factory defaults for all
functions, proceed as follows:
1. Turn off the printer.
2. While pressing the LOAD and, TEAR OFF buttons, turn on the
printer. Continue to press the two buttons until the printer beeps.
The factory defaults are now reset.
Another available method is to select INITIAL in SETUP mode.
The method of making settings is the same as the method for
selecting DEFAULT on the next page, except that INITIAL
must be selected instead of DEFAULT.
DEFAULTS
To Next Page
Loading...
