USING SETUP MODE
User's Manual 5-67
Resetting Factory Defaults in MENU1 and
MENU2
This method resets factory defaults for MENU1 and MENU2 options,
listed in Table 5.4, but does not reset the printer hardware, print position
adjustment, and configuration options.
Procedure (for LED type)
To reset the factory defaults in MENU1 and MENU2, select DEFAULT
in SETUP mode. Detail of method as follows:
1. Enter setup mode (LED type).
Press the SETUP button until the printer beeps. Wait for the
printer to stop printing and check that the following
<<FUNCTION>> menu is printed:
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-
HEX-DUMP V-ALMNT INITIAL
2. Select the DEFAULT function (LED type).
Repeatedly press the “TEAR OFF” or “LOAD” button to
position the cursor on the left edge of the aluminum print guide
on DEFAULT. Press the button or the button to select the
DEFAULT function. The printer reprints the <<FUNCTION>>
menu. The default values in MENU1 and MENU2 are now reset
(not saved yet).
3. Save reset values (LED type).
To exit setup mode and save the new defaults, make sure that
the cursor on the left edge of the aluminum print guide are
positioned on SAVE & END, then press the MICRO button
or the MICRO button.
To Next Page
Loading...
