Fujitsu DL7600Pro - Page 172

USING SETUP MODE
5-68 User's Manual
Procedure (for LCD type)
To reset the factory defaults in MENU1 and MENU2, select DEFAULT
in SETUP mode. Detail of method as follows:
1. Enter setup mode (LCD type).
Press the SETUP button at offline state. Check that the “SETUP
MODE” is displayed on LCD panel.
2. Select the DEFAULT function (LCD type).
Repeatedly press the “” or “” button to display “SUB
FUNCTION”. And then press the“” button to move lower
layer. And then repeatedly press the “” or “” button to
display “DEFAULT”. And then press the “SELECT” button to
reset the default values in MENU1 and MENU2 (not saved yet).
3. Save reset values (LCD type).
Exit setup mode, saving the factory defaults.
Push SAVE/EXIT button. Check that “:SAVE :CANCEL”
is displayed on LCD panel. Then press the“” button.