70
Basic operation
Displaying a memo
If memos have been set, a memo recorded corresponding to a
number button [1] to [5] appears on the screen when the number
button is pressed briefly while the power of the main unit is turned
off.
Setting a memo
Press and hold any number button for more than
two seconds while in the Standby mode.
The state shifts to the MEMO setting mode.
Press the [ ] button to select the character type.
Pressing the button will switch types from [ABC] (alphabet
characters) to [123] (numeric characters) and then [!&?]
(symbols).
Press either [SEL] or [ ] button to select the
position in which to enter the character.
The character will be inserted where the cursor is flashing:
[SEL] button: Moves the cursor to the right.
[ ] button: Advances the cursor to the left. Pressing and
holding the [ ] button moves the cursor to the
left.
Buttons [1] to [5] [SEL] button
[] button
[] button
CD8445.book 70 ページ ２００４年１２月１３日 月曜日 午前１１時３０分
To Next Page
Loading...
