Problem solutions and tips
Problem solutions and tips
Refer to the safety notes in the "Safety/regulations" manual and in th e "Getting
started", Page 13 chapter when connecting or disconnecting cables.
If a fault occurs, try to r
ectify it in accordance w ith the measures described in the following documents:
• in this chapter
• in the documentation relating to the peripheral devices
• in the Help sections fo
r the individual programs
• in the documen tation for the o perating system in use.
Help if problems occur
Should you encoun
ter a problem with your computer that yo u cannot resolve yourself:
► Note the ID number
of your device. The ID number is found on the type rating
plate on the back
, the underside or the top of the casing.
► Contact the Service Desk responsible for your country fo r clarification of the problem:
"
http://support.ts.fujitsu.com/contact/se rvicedesk". W hen you do this, please have
ready the ID number and serial number of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on your device
Cause
Troubleshooting
The mains voltage supply is faulty. ► Check whether the pow er cable is plugged
properly into the device and a grounded
mains outlet.
Internal power supply overloaded.
► Pull the power plug o f the device out of the
mains outlet.
► Wait app
rox. 3 min.
► Plug the power plug into a properly grounded
mains outlet again.
► Switc
h the device on.
28 Fujitsu
To Next Page
Loading...
Need help?
General