System expansions
System expansions
Upgrades,Device,System expansionComponentsServicing
Repairs to the device must only be performed by q ualified technicians. Incorrect re pairs
may greatly end anger the user ( electric shock, fire risk) and will invalidate your warranty.
After consulting the Hotline/Help Desk, you may remove and install the components
described in this manual yourself.
As the device has to be shut down i n order to install/deinstall system hardw are
components, it is a good idea to print out the relevant sections of this chapter beforehand.
The following illustrations may differ slightly from you r device, depending on i ts configuration level.
If further documentation was delivered with you r device, please also read this through carefully.
In addition, before removing or installing system components, please pay attention to the following:
The d evice must be switched off when installing/removing th e system
expansions and may not be in energy-saving mode.
Remove the power plug before opening the device.
Be careful that no w ires become trapped when removing or installing co mponents.
When installing components that b eco me very hot, make sure that the maximum
permissible temperature of the components in operation is not exceeded.
An update of the BIO S may be required for a system expansion or hardware
upgrade. Further in formation can be found in the BIOS help section or if
necessary in the Technical Manual for the mainboard.
32 Fujitsu
To Next Page
Loading...
Need help?
General