Fujitsu ESPRIMO D7 Series - Removing an M.2 Module

System expansio ns
Removing an M.2 module
► Remove the casing cover (see chapter "Removing the c asing cover", Page 34).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 45).
a
b
b
1
2
► Undo the screw (1)
.
► Pull the M.2 module (b) slightly at an angle in th e direction of the arrow (2) and out
of the s lot (a) on the mainboard and remove it from the c asing.
► Fold the drive
cage into the closed position a gain (see chapter "
Closing the drive cage", Page 46).
► Fit the casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 35).
If necessary, you must adjust the entry for the M.2 module accordingly in the BIOS Setup.
Fujitsu 59