System expansions
Removing a drive
► Remove the casing cover (see chapter "Removing the casing cover", Page 34).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 45).
► Disconnect any cables that are connected to the drive.
1
3
2
► Undo the screws (1 ).
► Push the drive a few centimetres out of the bay in the direction of the arrow (2).
► Pull the drive completely out of the bay in the direction of the arrow (3).
► Fold the drive cage into the closed position again (see chapter "
Closing the drive cage", Page 46).
► Fit the casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 35).
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
54 Fujitsu
To Next Page
Loading...
