Fujitsu fi-7460 - Operational

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
114
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■ Cover Open and Print Errors
Error codes beginning with the letter "U" are displayed.
J2:55 Multifeed
detected
(Overlap)
Press the Scan
button to eject the
document.
After ejecting the
document,
multifeed
detection for the
next document
can be enabled/
disabled from the
Menu button.
1 Press the [Scan/Enter] button on the
operator panel to eject the documents.
2 Press the [Menu] button on the
operator panel, select whether or not
to detect multifeed, and then press the
[Scan/Enter] button or perform a scan
from the computer.
Multifeed
detected
(Overlap)
Press the Scan
button to eject the
document.
Press the Menu
button to
memorize the
multifeed pattern.
1 Press the [Scan/Enter] button on the
operator panel to eject the documents.
2 Press the [Menu] button on the
operator panel, select whether or not
to memorize the pattern, and then
press the [Scan/Enter] button or
perform a scan from the computer.
Multifeed
detected
(Overlap)
Press the Scan
button to eject the
document.
1 Press the [Scan/Enter] button on the
operator panel to eject the documents.
2 Press the [Scan/Enter] button on the
operator panel or perform a scan from
the computer.
J2:56 Multifeed
detected (Length)
Press the Scan
button to eject the
document.
1 Press the [Scan/Enter] button on the
operator panel to eject the documents.
2 Press the [Scan/Enter] button on the
operator panel or perform a scan from
the computer.
Error
code
Error messages Action
J7:5F Feed mode
switched
Check the feed
mode switch
setting, reload the
documents and
try again.
Check the feed mode switch setting,
reload the documents and try again.
J8:01 Sensor(s) dirty
Clean the Pick
Sensor.
Open the ADF and clean the eight
document sensors.
For details, refer to "Chapter 5 Daily
Care" (page 91).
J8:04 Sensor(s) dirty
Clean the READ-
TOP Sensor.
Error
code
Error messages Action
U4:40
(*1)
ADF open Close the ADF and reload the
documents.
U5:4A
(*2)
Imprinter Cover
Open
(only when the
imprinter is
installed)
Close the print section of the imprinter,
and load the document again.
Error
code
Error messages Action