Fujitsu fi-7460 - Operational

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
118
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■ Motor Circuit Error
Error codes beginning with the letter "H" are displayed.
■ Option Error (When the Imprinter Is Installed)
Error codes beginning with the letter "A" are displayed.
Error
code
Error messages Action
H2:81
H8:88
Motor circuit error
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
Turn the scanner off then back on.
If the problem persists, write down
the displayed error code and contact
your FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
H6:B1 Imprinter system error
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
(only when the
imprinter is installed)
H7:84 Lamp circuit error
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
Error
code
Error messages Action
A0:B2 Imprinter error (RAM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
1 Confirm that the EXT cable of
the imprinter is connected
properly to the EXT connector
on the back of the scanner.
For details about the EXT
cable, refer to "Back" (page
16).
For details about how to
connect the EXT cable, refer to
the fi-748PRB Imprinter
Operator's Guide.
2 Confirm that the print cartridge
is installed correctly.
For details, refer to the fi-
748PRB Imprinter Operator's
Guide.
3 Turn the scanner off then back
on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an
authorized FUJITSU scanner
service provider.
A1:B3 Imprinter error
(communication timeout)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A2:B5 Imprinter error (print
head)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A3:B6 Imprinter error
(EEPROM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A4:B8 Imprinter error (ROM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.