Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
158
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Paper Protection Sensitivity
(page 172)
Specify the sensitivity level to detect anomalies
upon feeding the documents when paper
protection is enabled.
This setting can also be configured with the
operator panel. When the operator panel setting
is prioritized, the operator panel setting is
prioritized over the Software Operation Panel
setting.
Detect: Feeding Accuracy/Feeding Noise
Sensitivity: Low/Normal/High
Normal
Maintenance and Inspection
Cycle
(page 188)
Specify a cycle for the regular maintenance and
inspection that is performed on the scanner by
a service engineer.
Disable/Enable
Maintenance and inspection cycle: 1 to 12
months
Disable
Overscan Control
(page 174)
Set this to expand the amount of overscan and
output an image if part of the image appears
missing due to an abnormal skew during
overscan.
This setting can also be configured with the
operator panel.
Normal/Expand Normal
High Altitude Mode
(page 175)
Select whether to enable or disable high altitude
mode.
Enable to use the scanner at 2,000 m or higher
altitudes.
Enable/Disable Disable
Image Quality Mode
(page 175)
Set the image quality mode.
To obtain an image quality that is close to the
image quality for scanning with fi-5530C2, set
the image quality mode.
fi-5530C2/Disable Disable
Low-speed Feed Mode
(page 173)
Specify whether or not to reduce the scanning
speed to prevent paper damage.
This setting can also be configured with the
operator panel.
Disable/Enable Disable
Item Description Parameter/Value Factory Default
To Next Page
Loading...
