Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
87
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Intelligent Multifeed Function
The following three modes are available:
Select the mode by performing one of the following:
Select the mode in [12: iMFF Setting] on the [Settings Menu] screen
of the operator panel.
For details, refer to "3.2 Settings Menu" (page 55).
Select the mode in the Software Operation Panel.
For details, refer to "Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]" (page 181).
Preparation Before Using This Function
Before using this function, configure [Check Overlapping (Ultrasonic)] or
[Check Overlapping and length] for multifeed detection method by
performing one of following:
Configure the setting in the scanner driver.
For details, refer to the scanner driver's Help.
Configure the setting in the Software Operation Panel.
For details, refer to "Specifying a Multifeed Detection Method
[Multifeed]" (page 176).
Operational Procedure
Mode Description
Manual mode
(Bypass by front
panel button)
Checks for any paper attached every time a
multifeed occurs, and continues scanning.
Auto mode 1
(Bypass by
combination of
length and position)
Used to scan documents with paper of the same
size attached in the same location.
Auto mode 2
(Bypass by length)
Used to scan documents with paper of different
sizes attached in different locations.
ATTENTION
Irregular images may be output when multifeeds occur.
Me
n
u
Scan/Enter
Che
ck
Powe
r
Stop/Clear
[Scan/Enter] Button
LCD
[Menu] Button
To Next Page
Loading...
