Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
152
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
*1: Displayed when the imprinter is installed.
Item Description Parameter/Value Factory Default
Count
(page 159)
Check the counters to determine when to replace
the consumables and to perform cleaning.
Also use it to reset the counters when you have
replaced the consumables or performed
cleaning.
This setting can also be configured with the
operator panel.
Total Count(ADF)/After cleaning/Brake Roller/Pick Roller 0
Remaining Ink (when the imprinter is installed) (*1)
Power saving
(page 184)
Specify the waiting time for the scanner to enter
power saving mode.
This setting can also be configured with the
operator panel.
Range: 5 to 235 min. (in increments of 5) 15 min.
Power off after a certain period of time: Select to
set the scanner to turn the power off
automatically if the scanner is left on for a certain
period of time without being used.
Specify the timeout period for the scanner to be
automatically turned off.
This setting can also be configured with the
operator panel.
[Power off after a certain period of time] check box Selected
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time] check box
is selected)
4 Hours
Offset Setting
(page 164)
Adjust the position to start a scan on the selected
scanning side.
Unit: ADF (front)/ADF (back)
Main/Sub: -2 to 2 mm
(in increments of 0.5)
Main/Sub: 0 mm
Vertical
magnification
Adjustment
(page 164)
Adjust the magnification level in feed direction for
the selected scanning method.
Unit: ADF
Range: -3.1 to 3.1% (in increments of 0.1)
0%
To Next Page
Loading...
