Fujitsu fi-7460 - An Error (Error Code U4:40 or U5:4 A) Is Already Displayed in the LCD after Power-On; How to Use the Operator Panel

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
129
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
An error (error code "U4:40" or "U5:4A") is
already displayed in the LCD after power-on.
Does the problem persist after turning the power off then
back on?
No
The scanner is operating correctly.
Yes
Is error code "U4:40" or "U5:4A" displayed in the LCD
while the LED indicator is flashing?
Yes
Close the ADF and the print section of the imprinter (only when the imprinter is
installed) properly.
For details, refer to "1.4 Opening/Closing the ADF" (page 21).
If the indication does not return to the [Ready] screen after you closed the ADF,
check the items in "7.4 Before You Contact the Scanner Service Provider" (page
139) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU
scanner service provider.
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 139) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.