Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
86
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
2 Press the [] or [] button and select a parameter, then
press the [Scan/Enter] button to confirm.
Configure the application you want to launch when you press the
[Scan/Enter] button while the [Ready] screen is displayed.
Parameters in the [Function Selection] screen, application numbers in
the indicator, and events configured on the computer correspond to
one another as follows:
As an example, the following indicator displays an application number
"F02". This number is displayed by selecting [No.02] in the [Function
Selection] screen and performs the [Send to 2] event configured on
the computer.
3 Press the [Scan/Enter] button.
The specified application is launched.
Ignoring Multifeed for a Set Pattern
If you attempt to scan a document with an attachment such as
sticky note, receipt, or photo while multifeed detection is
enabled, the scanner may falsely recognize this as a multifeed
error and stop the scan. To scan these types of documents,
the "Intelligent Multifeed Function" is available.
There are two modes in this function. In one mode, you can
suppress multifeeds forcibly by using the operator panel on
the scanner. In the other mode, you can suppress multifeeds
automatically by letting the scanner memorize the location and
the length of the attachment.
Parameter in
the [Function
Selection]
screen
Application number
in the indicator
Event configured on
the computer
No.00 F00 [Scan Button]
No.01 to No.50 F01 to F50 [Send to 1] to [Send to
50]
SOP SOP N/A
Sticky Note
Receipt
or Photograph
Document
To Next Page
Loading...
