Fujitsu fi-7460 - Scanner Parts and Functions

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
15
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section shows the names of the scanner parts.
Front
1.2 Parts and Functions
Stacker
Stacks up the ejected documents.
Operator Panel
Consists of an LCD, buttons, and LED indica-
tor.
Can be used to operate the scanner or check
the status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 50).
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at a time from
the ADF paper chute (feeder).
Open this to replace consumables or to clean the inside
of the scanner.
Side Guides
Position the documents in place when the documents
are loaded in the ADF paper chute (feeder) as they are
fed into the scanner.
Chute Extension 2
Lift up from the front side to adjust the docu-
ment length.
ADF Paper Chute (Feeder)
Holds the documents to be scanned.
ADF Release Tab
Pull this tab to open the ADF.
Stacker Extension 2
Pull out towards you to adjust to the document length.
Chute Extension 1
Pull out to adjust to the document length.
Stacker Extension 1
Pull out towards you to adjust to the document
length.
Stacker Stand
Used to adjust the tilt of the stacker.
Side Guide Lock
Locks the side guide.
Feed Mode Switch
Slide the feed mode switch to the left to switch
the feed mode to Manual/Single mode.