RX100 S5 Operating manual 43
Hardware installation Installing/removing the server in/from the rac
3rd party rack
Certain general conditions must be met:
– Installation dimensions (see the dimensions shown in figure 2 on page 44):
– You must ensure that the safety mechanisms on the server, e.g. stoppers or
retaining systems, are functioning correctly.
– The shape of the rack support uprights must ensure that the rails can be
bolted to the front.
– Telescopic rails screwed to the front.
The rails have a linear alignment feature to ensure that they can be adjusted
to different rack depths.
– Climatic conditions:
To ventilate the server, an unimpeded air inlet on the front of the rack and an
air outlet on the rear of the rack are required.
In principle the ventilation concept envisages that the necessary cooling is
achieved by the horizontal self-ventilation of the installed devices (air flow
from front to back).
1 Front of rack
2 Rear of rack
A Rack depth (comparison PRIMECENTER rack 940/1000/1100 mm)
B Rack width (comparison PRIMECENTER rack 700 mm)
C Clearance for 19” installation level
C1 Front 19” installation level
C2 Rear 19” installation level
D Cable routing area (cable area depth) and ventilation
E Space for front panel and ventilation
F Space for right and left support systems
P PRIMERGY rack installation depth
a1 Front left support upright
a2 Front right support upright
b1 Rear left support upright
b2 Rear right support upright
To Next Page
Loading...
