48 Operating manual RX100 S5
Installing/removing the server in/from the rack Hardware installation
4.2.3 Installation in 3rd party racks
The following parts are required to install the server in 3rd party racks:
– One left and one right telescopic rail (assembled)
– M5x10 screws with integrated plugwashers
Ê Refer to the manual from the rack manufacturer for details of the mechanical
installation and the climatic conditions.
V CAUTION!
When installing in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
Ê Fit the required original parts (e.g. support bracket).
I Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Ê Remove the outer telescopic rail as described in page 46 (figure 4).
To Next Page
Loading...
