RX100 S5 Operating manual 69
Starting up and operation Configuring the server
5.3.4 Configuration with ServerStart
The ServerStart disc 1 supplied allows you to conveniently configure the server
and install the operating system. The menu-assisted configuration includes the
server configuration with SCU and the RAID controller configuration with
ServerViewRAID.
The ServerStart advantages
– Automatic configuration of your server’s hardware and disk arrays.
– Installation assistance for all leading server operating systems.
– Creation of configuration files for unattended installation of several
PRIMERGY servers with identical hardware configurations.
– Installation of drivers and additional software.
I The software that can be installed depends on your server’s hardware
configuration. This configuration is detected automatically.
I Descriptions of operating systems not covered in the RAID controller
manual are provided in the corresponding readme files on the driver
CDs.
To find out how to operate ServerStart and for further information, refer to the
associated manual.
If you are using ServerStart, you can skip the following section on how to
configure the server and install the operating system. Continue from section
“Cleaning the server” on page 70.
To Next Page
Loading...
