Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
19
2. Attach Water Pump Fitting: Remove the water pump from its packaging. Attach the
plastic tting to the water pump by gently screwing it on.
3. Prep Water Bucket: Fill a clean 5 gallon bucket (not included) with 3 - 4 gallons of distilled
water (not included). ALWAYS use only distilled water and replace often. It is recommended that you
choose a bucket with a lid and cut holes to allow the tubes to t. This will prevent debris falling into
your water bucket.
Water Line
Figure 3.7
Figure 3.8
To Next Page
Loading...
