What to do if Furuno 1815 Marine Radar picture is not updated or freezes?
If your Furuno Marine Radar picture isn't updating or is freezing, check that the signal cables of bearing signal generator are fastened. If they are secured, replace the SPU board. Also, try turning the radar off and on again.
Why is Furuno 1815 not working correctly in true motion presentation?
If the true motion presentation on your Furuno Marine Radar isn't functioning correctly, check that the [Display Mode] in the [Display] menu is set to [True Motion]. Also, verify that the heading and position data are being input correctly.
What to do if Furuno Marine Radar set to maximum gain shows marks but no noise or echo?
If your Furuno Marine Radar displays marks and indications but no noise or echo when the gain is at maximum and sea clutter is at minimum, the problem could be with the signal cable, IF amplifier, or video amplifier board. Check the continuity and isolation of the coaxial cable. If the cable is good, replace the IF amplifier. Also, check the coax line for a secure connection; if the connection is good, replace the SPU board.
Hazards related to RF radiation exposure from the radar antenna.
Warning against opening the equipment due to high voltage risks.
Procedures for water ingress or fire incidents to prevent electrical shock.
Warning against unauthorized modification to avoid injury or damage.
Instructions for mounting the display unit on a desktop or flush mount.
Guidelines and considerations for selecting a mounting location for the antenna.
Steps and precautions for connecting the power cable to the antenna unit.
Instructions for connecting the display unit to other equipment and power.
Guidelines and precautions for grounding the display unit to prevent interference.
Accessing and performing initial setup procedures for the radar.
Description of the display unit's keys, knobs, and cursorpad.
Steps for powering the radar on/off and initiating transmission.
Procedures for manual tuning to optimize radar performance.
Methods to minimize sea clutter interference for clearer target detection.
Methods to minimize rain clutter interference for clearer target detection.
How to activate the interference rejector to reduce radar interference.
Methods for measuring the distance to a detected target.
Using the Electronic Bearing Line (EBL) to measure target bearing.
General| Display Size | 10.4 inches |
|---|---|
| Type | Marine Radar |
| Power Output | 4 kW |
| Antenna Type | Open Array |
| Display Type | LCD |
| Rotation Speed | 24 RPM |
| Range | Up to 36 nautical miles |
| Frequency | 9410 MHz ±30 MHz |
| Range Scales | 6, 12, 24, 36 NM |
| Beam Width | 25° (Vertical) |
| Range Resolution | 20 meters |
| Display Modes | True Motion |
| Power Supply | 24 V DC |
To Next Page