Furuno FELCOM 15 - Page 59

3.1 Terminal unit, IC-215
3-7
Note 2) Disconnecting flat cable from J9
To disconnect the flat cable;
1. Release the locking tabs by pushing the tabs toward the cable. Excess force will
damage the connector.
2. Pull out the cable.
To connect the cable, reverse the above procedure.
Fig.3.1.12 Flat cable connector, J9
Note 3) Disconnecting flat cable from FDD connecter
To disconnect the flat cable;
1. Release the locking tabs by pushing the tabs toward the cable. Excess force will
damage the connector.
2. Pull out the cable.
To connect the cable, reverse the above procedure.
Release tabs.
1 mm
Fig.3.1.13 FDD connector
Flat cable
Pushing with equality power
about 1mm slowly.