FUTABA T18SZ - Page 29

29
＜ BeforeUse ＞
Turnscrewclockwise.
Sticktensionmaximum
Sticktensionminimum
Turnscrewcounter-clockwise.
1.5mm hexagonal wrench
1.5mm hexagonal wrench
•Stick Tension (J2)
(Mode 2)
•Stick Tension (J1)
(Mode 1/2)
•Stick Tension (J4)
(Mode 1/2)
•Stick Tension (J3)
(Mode 1)
5. At the end of adjustment, reinstall the side
cover and rear grips.
Use the attached 1.5mm hexagonal wrench
LQVLGHVW\OXVWRWXUQWKHVFUHZFORFNZLVHWRDGMXVW
the stick outwards, or counter-clockwise to tilt it
inward.
Note: Be careful not to turn the screw too far
counterclockwise as it could fall out.
ŤƇƍƘƖƗƐƈƑƗŃƒƉŃƗƋƈŃƖƗƌƆƎŃƏƈƙƈƕŃ
ƄƑƊƏƈ
<RXFDQPDNHILQHDGMXVWPHQWVWRWKHDQJOHRI
a stick lever either inwards or outwards from the
center stick position.