FUTABA T18SZ - Page 31

31
＜ BeforeUse ＞
CAUTION
Besuretoturnoffthepowertothe
transmitterbeforeinsertingorremoving
theSDcard.
AstheSDcardisaprecisiondevice,do
notuseexcessiveforcewheninserting.
ŶŧŃƆƄƕƇŃƕƈƄƇƈƕŒƚƕƌƗƈƕ
Saving model data and update files (released
from Futaba) into the SD card, you can use those
files on your T18SZ transmitter. Equipment for
reading and writing SD cards is available at most
electronics stores.
ŶƗƒƕƈƇŃƇƄƗƄ
When you have a problem of saving or reading
data after a long period of use, please get a new SD
card.
*We are not responsible for, and offer no compensation for,
memory card data that fails or is damaged for any reason.
Be sure to keep a backup of all important data stored in your
SD card.
ŶŧŃŦƄƕƇŃŋƖƈƆƘƕƈŃƇƌƊƌƗƄƏŃƐƈƐƒƕƜŃƆƄƕƇŌŃŋƑƒƗŃƌƑƆƏƘƇƈƇŌ
SD card slot
②TheSDcardslotis
shownhereinthe
figurebelow.

*Payattentiontotheproperorientationof
theSDcard,asshownhere.
slot

is

in
th
h
e
e
e
w
.
o

the
the
pr
pr
p
ope
ope
p
ro
ro
i
rie
rie
t
nta
nta
ti
tio
tio
no
no
f
f
f
f
hh
SD card slot
Batterycover

The T18SZ transmitter model data can be stored by using any commonly found SD card. When
T18SZ transmitter update software is released, the software is updated using an SD card. The T18SZ is
capable of using SD cards with a memory size between 32MB and 2GB.
①Thesidebatterycover
isremove-able.
③ WhentheSDcard
ispressedinonce
again,thecardwill
bereleasedfromthe
cardslotandcanbe
removed.
ŬƑƖƈƕƗƌƑƊŒƕƈƐƒƙƌƑƊŃƗƋƈŃŶŧŃƆƄƕƇ