FUTABA T6K-V2 - Throttle Cut (THR CUT)

122
Helicopter
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+
keyfor1second.
＋
② Select
fromthemenuwiththe
Jogkey.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
THRCUT
Throttlecut
(HELICOPTER)
■ Mode
①Selectthe"MODE"itemandthenselectthe
modebypressingthe+keyor‒key.
＋ −
or
Range：NOR,ESC
Default：NOR
● "NOR"：Enginemodel
 "ESC"：Electricmotormodel
■Activatingthefunction
②Selectthe"MIX"itemandthenselecttheoff
bypressingthe+keyor‒key.
＋ −
or
● Whenyoudonotuseafunction,settothe
"INH"side.
ThrottleCut
This function cuts (stops) the engine or motor
by stick operation. At throttle operation, the rate is
adjusted to the position which completely cuts the
throttle servo or ESC when the throttle is operated.
When THR CUT is active, the throttle position is
held regardless of the throttle stick position.
ŏ7KHWKURWWOHSRVLWLRQZKHQWKHIXQFWLRQ LVUHVHW
FDQEHVHWVRWKHPRWRU ZLOOQRWXQH[SHFWHGO\
UXQDWKLJKVSHHGZKHQWKHWKURWWOHFXWIXQFWLRQ
LVUHVHW:KHQWKHWKURWWOHVWLFNLVKLJKHUWKDQWKH
VHWWKURWWOHSRVLWLRQWKHWKURWWOHFXWIXQFWLRQLVQRW
UHVHWHYHQLIWKHVZLWFKLVVHWWR2))6HWWRDVDIH
WKURWWOHSRVLWLRQVORZVLGH
125(6&PRGHWKHQH[WSDJHUHIHUULQJ
ŏ)XQFWLRQRSHUDWLRQFDQEHVHOHFWHGIURPDPRQJ
VZLWFKHV$
-
'
ŏ6HWWKHWKURWWOHFXWIXQFWLRQIRUVDIHW\DOVR
"THRCUT"
Mode
CutPositionrate
ThrottlePosition
Switchselection
● WhennotusingthisFunction
selectINH.ThedisplayofOn/
Offisshownwhenactiveand
assignedtoaswitch.
● Adjuststheratetotheposition
thatcompletelycutsthe
throttleservoorESC.
● Thevalueinparenthesesisthe
currentthrottlestickposition.
● Select t
he
setting item with
the
Jog key
.
● SetstheON/OFFdirectionoftheselectedswitch.
○ 2PSW：NULL,UP,DOWN
○ 3PSW：NULL,UP,UP&D,UP&C,CNTR,C&DN,DOWN
Activatingthefunction