FUTABA T6K-V2 - Date Reset; Model Copy

54
Commonfunction
① SelecttheCOPYitemandtheselect
themodelnumberofthecopydes-
tinationbypressingthe+keyor‒
key.
＋ −
or
Selectionrange：1-30
② PresstheJogkeyfor1sec-
ond.
（1second）
● Confirmationmessage
"sure?"blinks.
③Copythemodelbypressingthe
Jogkey.
● Aconfirmation"beep"
soundsand"Complete"
isdisplayedonthescreen
toshowthatcopyingis
complete.
Forsafety,adoublesettingsystemisused.Whenachangeiscancelledaftertheconfirmationmessageis
displayed,thechangeisnotmadewhenmovedtoanothersettingitembyJogkey.
① SelecttheRESitemandthenpresstheJogkey
for1second.
（1second）
● Confirmationmessage"sure?"blinks.
② DateresetbypressingtheJogkey.
● Aconfirmation"beep"soundsand
"Complete"isdisplayedonthescreenis
complete.
Forsafety,adoublesettingsystemisused.Whenachangeiscancelledaftertheconfirmationmessage
isdisplayed,thechangeisnotmadewhenmovedtoanothersettingitembyJogkey.
Modelcopy
Datereset
CAUTION
ThrottleReverse
Only the throttle channel (CH3) initial setting is REV (reverse). Thoroughly check the
Hi and Low directions of the engine or motor used and be careful that they do not
suddenly run at full speed. Even after data reset, CH3 is reversed.
MDLSELPAGE2
● Originaldata:Modeltype
Modelname
● Copyplace:ModeltypeModel
name