FUTABA T6K-V2 - Servo Monitor; Servo Test

74
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
CAUTION
Using the servo test will move the servos to
their full throw. Do not use this with linkages
installed. Using it may damage the servo
and linkage.
The servo display/servo test function displays the
CH1 to CH8 servo output bar graph and tests servo
operation.
ŏ7KHVHUYRGLVSOD\IXQFWLRQFDQEHXVHGIRUDVLPSOH
RSHUDWLRQFKHFNRIVXFKIXQFWLRQVDVWKHPL[LQJ
IXQFWLRQ
ŏ:KHQWKHVHUYRWHVWIXQFWLRQLVWXUQHGRQWKHVHUYR
PRYHVWRWKHOHIWDQGULJKWDWWKHVHWSHULRG$
YDULDEOHVSHHG/15OLQHDUPRGHRUÀ[HGVSHHG
-03MXPSPRGHFDQEHVHOHFWHG7KLVFDQEH
XVHGWRFKHFNWKHVHUYRHWF2SHUDWLRQ212))
FDQDOVREHVHOHFWHGIRUHDFKFKDQQHO
"SERVO"
SERVO
Servomonitor ／ Servotest
(Common)
(ServoMonitor）
● Selectthesettingitem
withtheJogkey.
Switchingtotheservotest
screen
● Switchthescreenbyselecting
TESTandoperatingthejog
keytotheleftandright.
● Theservooperatingposition
ofeachchannelisdisplayed
onabargraph.
(ServoTest）
ServotestON/OFF
ChannelSelect
Screenchange
● Where"GRPH"ischosen,a
Jogkeyispressedinrightor
left.
TypeSelect
CycleSelect
Speedsetting
● Operationofaservotest
■ Type/cycle/speedsetting
① Selectthesettingitem(TYPE,CYCL,
SPD)withtheJogkeyandsettheitem
bypressingthe+keyor‒key.
＋ −
or
（Range ／ Default）
TYPE：LNR,JMP ／ LNR
CYCL：1-100 ／ 10（fullspeedat1）
SPD：1-100 ／ 7（fullspeedat100）
■ Channelselection
② Selectthechannelyouwantto
testwiththeJogkeyandselect
ACT/INHbypressingthe+key
or‒key.
＋ −
or
Selectionrange：ACT,INH
Default：INH（onlyCH1isACT）
■ Servoteststart/stop
③Selectthe"TEST"item
withtheJogkeyand
start/stoptheservotest
bypressingthe+keyor‒
key.
＋ −
or
Selectionrange：ON,OFF
Default：OFF
Servotest