FUTABA T6K-V2 - Program Mixing (P.MIX)

70
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
P.MIX1-3(normaltype)
Thefollowingfunctionscanbesetforprogrammablemixing1to3:
【MixingChannel】
● Usethisfunctionbychangingthechannelbecausethemasterchannelandslavechannelsinitialsettingisa
temporarycombination.
● WhenOFSwasselectedasthemasterchannel,themixingratesettingappliestoslaveonly.Whenamixing
rateisset,slaveservooperationisoffsetbythatamount.
● AVRaswellasachannel,canbeselectedasthemasterchannel.
【Trimselection】
● Whetherornotmixingincludesmasterchanneltrimoperationcanbeselected.
【Mixingreferencepointchange】
● Themasterchannelmixingreferencepointcanbeshifted.
【Switchselection】
● TheprogrammablemixingON/OFFswitchcanbeselected.TheswitchesthatcanbeselectedareswitchesAto
Dandthethrottlestick.
● Theswitchoperatingdirectioncanbeset.Whena2positionswitchwasselected,up/downcanbeset,and
whena3positionswitchwasselected,up/upanddown/up/andcenter/center/centeranddown/downcan
beselected.Whenthethrottlestickwasselected,theON/OFFpositionandoperationdirectioncanbeset.
When"NULL"isselected,mixingisalwaysON.
P.MIX4（curvetype）
Programmablemix4allowssettingofthemixingrateby5pointcurve.
OFSandVRuseandtrimselectionbynormaltypemasterchannelsettingdescribedaboveare
impossible,butswitchselectionispossible.
Mixing that can independently customize 4
functions can be used. Programmable mixing is
used to remove bad tendencies of the aircraft and
PDNHRSHUDWLRQSOHDVDQW,QDGGLWLRQWRPL[LQJ
between arbitrary channels, trim addition, offset,
and switch setting functions.
"P.MIX"
P.MIX
Programmixing
(Common)