GAT Access 6100 Terminal Series
Installation
26
HB_GAT-ACCESS6100--EN_14
www.gantner.com
Figure 3.10 - Installing the GAT Access 6100 F rear part
Opening the GAT Access 6100 F Front Part
The device can only be opened with the supplied special tool! With this, the two catches on the bottom of the device
can be unlocked in succession.
Figure 3.11 - Opening the housing
Maintenance
The sensor field of the GAT FR 055 should be cleaned periodically to ensure that the fingerprint can be clearly
scanned.
NOTE! Always use a damp (not wet!), smooth cloth to clean the sensor field. Acrid detergents and sharp materials
must not be used.
To Next Page
Loading...
