68 232003110G (03)
4.2 Graphics Software Setup
The LaserPro S400 is compatible with graphics software that can output HPGL commands, such as
CorelDRAW, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported
Graphic
Software
• Photoshop
• CorelDRAW
• Illustrator
• AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro S400, but LaserPro
does not guarantee 100% compatibility for those software and will not provide technical support for them.
Technical support will not be offered, if you experience output problems with
non-supported graphics software.
4.2.1 Recommended Computer Configuration
The LaserPro S400 operates under Windows operating systems and is designed to work on a
computer that meets the following minimum requirements.
Computer Compatibility
• CPU – Pentium 90 (or equivalent) or greater
• RAM – 32 MB or higher
• HDD – 1.2 GB Hard Drive or greater
• SVGA – 15" Super VGA Monitor
•
On Board Parallel Mode (Enabled from motherboard’s BIOS)
• SPP – Preferred Mode
• ECP – Cable (Less than 1.8 meters)
Software Compatibility
• The LaserPro S400 drivers are designed for Windows Vista, 7, 8, or other operating systems
developed subsequently.
4.3 Installation of the LaserPro Print Driver
1) Insert the LaserPro CD.
2) From the auto run menu, select Model Name,
L
a
s
e
r
P
r
o
D
r
i
v
e
r
to begin the LaserPro Print
Driver installation.
3) When the Add Printer Wizard menu comes up, click Ne
x
t
to continue.
4) At the Local or Network Printer page, select <
Lo
c
a
l
p
r
i
n
t
e
r
a
tt
a
c
h
e
d
t
o
t
h
i
s
c
o
m
pu
t
e
r
>, then click
Ne
x
t
to continue.
5) At the Select a Printer Port page, select <U
s
e
t
h
e
f
o
ll
o
w
i
ng
po
r
t
> and select the port that the
LaserPro S400 will be attached to, then click Ne
x
t
to continue.
6) The next screen will prompt you with a list to select the manufacturer and model of your printer.
From this menu, click Ha
v
e D
i
sk
. Another menu will now pop up for you to indicate the location
of the print driver. With the LaserPro CD still in your drive, click
B
r
o
w
s
e, select the LaserPro S400
driver folder and locate the GL345.inf file. Click OPEN to have S400 displayed as a valid printer.
To Next Page
Loading...
