69 232003110G (03)
7) Now select S400 from the list of printers (S400 should be the only printer displayed on the
list) and click Ne
x
t
to continue.
8) If a screen comes up informing you of the detection of a previous driver and asks to keep
the existing driver or use the new one, select <Re
p
l
a
c
e E
x
i
s
t
i
ng
D
r
i
v
e
r
> and click Ne
x
t
to
continue.
9) This screen will prompt you to provide a printer name. Simply type in <S400> and select
Ye
s
or N
o
if you want to use this printer as the default printer and click Ne
x
t
to continue.
NOTE
When working with the LaserPro S400 Print Driver within your graphics software, you
will need to have the S400 set as the default printer to get proper output. If you select to
not have the S400 be the default printer, please remember to manually change this
on your own from within the graphic software printer selection area or from the Windows
Control Panel Printers and Faxes section.
10) At the Printer Sharing screen, select <D
o
no
t
s
h
a
r
e
t
h
i
s
p
r
i
n
t
e
r
> and click Ne
x
t
to continue.
11) Select <N
o
> when asked if you want to print a test page and click Ne
x
t
to continue.
12) Now simply click F
i
n
i
s
h
to complete the Add Printer Wizard.
13) Now the installation will proceed, if you get a Hardware Warning about the software you are
installing for this hardware has not passed Windows Logo testing, simply click C
on
t
i
nu
e
A
n
y
w
a
y
to ignore this warning.
14) Congratulations, your printer driver has been successfully installed!
4.4 Paralle Desktops for MAC Users
MAC users can use GCC LaserPro machines by purchasing the Paralle Desktop software which allows you
to install Windows OS in MAC computers and run Windows based software under MAC computer and
output with GCC print driver.
1) Purchase Paralle Desktops on its official website.
To Next Page
Loading...
