GE Security Vigilant VS1 User Manual

Chapter 2: Front panel programming
Vigilant VS1 and VS2 Technical Reference Manual 39
• Mapping: No
• Loop 2 enable: No
• Loop 2 Fst Grp: 1 to 25
Default contact ID event codes
Contact ID codes are used to report events that take place in the fire alarm system to
a central monitoring station (CMS) via a dialer or over a network. The following table
lists the default Contact ID (CID) codes for panel and loop events. Some events do not
have CID codes. You can change the default code for an event or assign a code to an
event that does not have one. See “Event programming” on page 120.
Table 8: Contact ID event codes
Event CID
AC power (disable) 500
AC power (trouble) 301
Alarm active 110
Annunciator trouble 334
Aux. power 1 (disable) 500
Aux. power 1 (trouble) 312
Aux. power 2 (disable) 500
Aux. power 2 (trouble) 312
Battery charger (disable) 500
Battery charger (trouble) 309
Battery low (disable) 500
Battery low (trouble) 302
Battery missing (disable) 500
Battery missing (trouble) 311
Clear history 621
Common alarm 110
Common disable 500
Common monitor 140
Common supervisory 200
Common trouble 373
Common trouble for network dialer 373
Common trouble for telco dialer 373
Event CID
Date 625
Device trouble 373
Device disable 570
Device pre alarm 118
Device alarm verify 118
Device maintenance alert 393
Device test 614
Dialer disable/remote disconnect 551
Dialer line 1 fault (disable) 500
Dialer line 1 fault (trouble) 351
Dialer line 2 fault (disable) 500
Dialer line 2 fault (trouble) 352
Dialer deliver fail 354
Dialer normal test 602
Dialer abnormal test 608
Dialer configuration 354
Drill 601
Duct active 116
Ground fault (disable) 500
Ground fault (trouble) 310
Heat active 114
Internal fault 307

GE Security Vigilant VS1 Specifications

General

Brand	GE Security
Model	Vigilant VS1
Category	Control Panel
Language	English