EasyManuals Logo

GE Corometrics 250 Series User Manual

GE Corometrics 250 Series
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
3-6 250 Series Maternal/Fetal Monitor Revision D
2020551-001
Installation: Power
Mode
This field selects the mode for communication and must be compatible with the
external device. Use the Trim Knob control to cycle through the available settings:
Nellcor, Factory, Critikon, 1371, and 1371/Notes. (Each port is factory set to the Nellcor
mode.)
NOTE: The Factory mode is reserved for factory testing only.
Communications Setup Screen
Power
1. Ensure the Power switch is in the off (O) position.
Turning the Monitor On/Off
2. Connect the detachable line cord to the rear panel power connector; plug the
other end into a hospital grade grounded wall outlet of appropriate voltage. (If
you are unsure about the voltage, contact your hospital Biomedical Engineering
Department or GE Service Representative.)
Monitor ID
250

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Corometrics 250 Series and is the answer not in the manual?

GE Corometrics 250 Series Specifications

General IconGeneral
BrandGE
ModelCorometrics 250 Series
CategoryMedical Equipment
LanguageEnglish

Related product manuals