Appendix G: Accessories
261
SUPPORT ARM FOR BREATHING CIRCUIT
The Support Arm for the breathing circuit is used for securing the patient circuit
when the iVent
TM
201 device is mounted on to a roll stand (VersaMed PN
630B0001-02, GE PN. M1162044).
CONNECTING THE PATIENT CIRCUIT TO THE
SUPPORT ARM
1. Place the Support Arm base on the roll stand frame, as shown in Figure 194.
2. Turn the lower screw (A in Figure 195) to fasten the Support Arm to the roll
stand.
CAUTION The side screw (B in Figure 195) fastens the Support Arm to its base. Do not
open this screw.
Do not over tighten the screws as this might cause damage to the Support Arm
Figure 194: The Support Arm based on
Roll Stand frame
Figure 195: Support Arm Base Screws
Figure 196: Twin Tube Holder
Figure 197: The Support Arm's Latch
To Next Page
Loading...
