GE iVent 201 Series - Introduction to Setup Procedures; Connecting to External Power Sources

20
DISPLAYED PARAMETERS
The following table presents the displayed parameters and indicates whether the
displayed values are set, measured or both.
Parameter
Unit of
Measure
Set
Displayed
Rate bpm + +
Ventilation Mode + +
Oxygen Concentration FiO
2
+ +
Inspiration to Expiration
time ratio I:E ratio
+
Inspiratory Time (I
time
) sec + +
Sensitivity Values
(Triggers): Pressure and
Flow
cmH
2
O/LPM + +
Pressure Support
Ventilation (PSV)
cmH
2
O +
Flow termination (Esens) % +
Rise time (drive) + +
Alarm Pressure / Limit
Pressure
cmH
2
O + +
Positive End Expiratory
Pressure (PEEP)
cmH
2
O + +
Exhaled Minute Volume L +
Peak Inspiratory Pressure cmH
2
O +
Pressure/Flow Wave
Forms
+
Electrical Power Source
(Ext./Int.)
+
SpO2 % +
Heart rate Bmp +
In Adaptive Bi-Level
Mode:
IPAP (Ins Pressure) cmH
2
O + +
EPAP (Exp. Pressure) cmH
2
O + +
Tidal Volume (estimated) mL +
Leak (estimated)* LPM +
Rise Time Setting sec +
Non-Displayed Additional
Parameters