GE iVent 201 Series - Page 97

3 Operating the iVentTM201 – Setting Modes and Parameters
85
Figure 71: Esens Selected on the Main Screen
Or select the Esens option in the Mode Parameters screen (Figure 72):
Figure 72: The Esens Option Selected on the Mode Parameters Screen
2. Press the Control Knob. The Set Flow Term pop up window appears
(Figure 73):
Figure 73: The Set Flow Term Pop Up Window
3. Turn the Control Knob to change Flow termination percentages.
4. Press the Control Knob to confirm and accept the settings.